back to instructions page
back to LED QuickMount Kit
LED QuickMount Kit Instructions
Internal Window Mount Installation Instructions
CAUTION: The adhesive backed tape used to secure the light is a very aggressive contact tape
that is virtually impossible to remove or relocate.
Before removing the cover film from the tape to expose the adhesive surface,
hold the assembly against the glass surface and select the optimum location for your purposes.
(For windshield mounting, to insure maximum light output, we suggest that the upper edge of the
light be positioned just below the tinted area of the windshield.)
Bend the mounting
bracket as necessary to allow light assembly to be hung securely.
Once you have chosen
the location and adjusted the mounting bracket as necessary, clean the mounting area with
the provided alcohol swab. Place a strip of masking tape horizontally below the mounting
location to act as a guide in the final positioning of the light.
THEN AND ONLY THEN, remove the cover film from the foam tape adhered to the
mounting bracket. Place the bottom edge of the foam tape surface against the upper edge of the
masking tape. Tilt the bracket upward to adhere the tape to the glass, and apply pressure to the back
of the foam tape portion of the bracket to secure it and to remove any trapped air.
Once the light has been mounted in the desired position, route the cord to the
cigarette lighter socket, or accessory socket using the cord clips provided.